Publicidad
FCC COMPLIANCY STATEMENT
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference
2) This device must accept any interference received, that may cause undesired operation.
Warning: Changes or modification to the equipment not approved by Laney can void the user's authority to use the
equipment.
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
---------------------------------------------------------------------------------------------------------------------------------------------------------
This product conforms to the requirements of the following European Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage 2014/35/EU, EMC (2014/30/EU), RoHS (2011/65/EU), RED (2014/30/EU), ErP
2009/125/EU
---------------------------------------------------------------------------------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with
normal household waste to landfill sites. It must be taken to an approved recycling centre according to the
recommendations of the WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
---------------------------------------------------------------------------------------------------------------------------------------------------------
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Laney Electronics Ltd. declares that the radio equipment is in compliance with Directives 2014/53/EU, 2011/65/EU,
2009/125/EU
Full text of the EU declaration of conformity is available at the following internet address:
support.laney.co.uk/approvals
---------------------------------------------------------------------------------------------------------------------------------------------------------
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Headstock Distribution Ltd is under license. Other trademarks and trade names are those of their respective
owners. Laney is a registered trademark of Headstock Distribution Ltd.
INCORPORATED RADIO EQUIPMENT DEVICE TECHNICAL SPECIFICATION:
Frequency Range:
Transmit Power:
Receiver Sensitivity:
Operating Protocol:
---------------------------------------------------------------------------------------------------------------------------------------------------------
2402-2480MHz
+8dBm (6.3mW)
-91dBm
Bluetooth Class 2
EN
Publicidad
