Publicidad
Idiomas disponibles
Idiomas disponibles
17. Accessories : Use only accessories appropriate for this tool.
18. Maintain tools carefully : Keep cutting tools sharp and clean for better and safer performance. Follow
instructions for lubricating and replacing accessories. Examine tool cables/cords regularly and have
them repaired, if damaged, by an authorized service center.
19. Do not modify the machine : no modification and/or reconversion must be carried out. Use of
accessories or attachments other than those recommended in this instruction manual may result in
personal injury.
20. Keep handles dry, clean and free of all lubricants and grease.
21. Disconnect tools : Disconnect tools from power when not in use, before servicing, and when replacing
accessories, such as blades, drill bits, and cutters.
22. Remove adjustment keys : Make it a habit to check that keys and other adjustment components are
removed from the tool before turning it on.
23. Avoid any accidental starting : ensure that the switch is in the "off" position when connecting.
24. Use external connection cables : When the tool is used outdoors, only use extensions intended for
outdoor use and bearing the corresponding marking.
25. Stay alert : watch what you are doing, use common sense and do not use the tool when you are tired.
26. Check Damaged Parts : Before using the tool for any other purpose, it should be carefully examined
to determine that it will function properly and perform its intended function. Check the alignment or
locking of moving parts, as well as the absence of any broken parts or any fixing conditions and other
conditions, which could affect the operation of the tool. A guard or other damaged part should be
properly repaired or replaced by an authorized service center unless otherwise specified in this
instruction manual. Have defective switches replaced by an authorized service center. Do not use the
tool if the switch does not change from on to off.
27. Risk of burns: Allow moving parts (tip) to cool before touching them.
28. Have the tool repaired by a qualified person : this electric tool meets the corresponding safety
regulations. Repairs should only be carried out by qualified persons using original spare parts.
Otherwise, this may expose the user to significant danger. Contact the manufacturer to obtain
replacement of damaged labels.
WARNING :
The use of any accessories or attachments other than those recommended in this
instruction manual may present a risk of injury to persons.
1.2.
Special Instructions
1.2.1.
General safety rules
Multiple hazardous phenomena, read and understand the safety instructions before installing,
operating, repairing, maintaining, changing accessories on or working near the portable assembly
machine. Failure to follow these instructions may result in serious personal injury.
Only qualified and experienced operators should install, adjust or use the portable assembly machine.
Do not modify this portable assembly machine. Modifications may reduce the effectiveness of safety
measures and increase risks to the operator.
Do not neglect the safety instructions; entrust them to the operator.
Do not use the portable assembly machine if it has been damaged.
Machines shall be checked periodically to verify that the ratings and markings required by this part of
ISO 11148 are legibly marked on the machine. The employer/user must contact the manufacturer to
obtain replacement labels if necessary.
1.2.2.
Dangerous phenomena due to projections
Breakage of the part, accessories or the tool itself can generate high-velocity projectiles.
Wear impact-resistant eye protection at all times when operating the portable assembly machine. The
appropriate level of protection should be assessed for each use.
Make sure the part is firmly attached.
SODISE 85 Route de Pont Gwin 29510 Briec FRANCE
NIU 06982 V.1.8
16
Publicidad
