Publicidad
Idiomas disponibles
Idiomas disponibles
Do not use oil with too high a viscosity to lubricate as this may reduce the power of the impact wrench.
Do not use quick disconnects at the tool inlet, use threaded hose connectors made of hardened steel
(or a material with comparable strength).
Do not exceed the maximum pneumatic pressure indicated on the device.
Never carry a pneumatic machine by the hose.
3.2.
Start-up
Connect the air inlet to your ratchet wrench with the universal adapter provided. Put Teflon film on the
thread of the connection.
Put a nut on the square. Choose the correct direction of rotation.
Press backwards (reverse rotation) to unscrew.
Press forward (clockwise rotation) to screw.
Install the square in the nut and squeeze the trigger.
4. Maintenance
WARNING :
Be sure to wear all required equipment when working on the tool.
To avoid serious injury, before carrying out maintenance, disconnect the tool from the
compressed air network.
-
Use appropriate protection to protect yourself during maintenance operations.
-
Regular preventative maintenance keeps tools in safe operating condition.
-
Regularly check the spindle, thread, and clamping devices for wear.
-
Check that the connections are screwed correctly, tighten them if necessary.
-
If significant loss of oil and air occurs, check the tool and have it repaired if necessary.
-
After each use, check the rotation speed and vibration level. If the level of oscillations is greater, have
the tool repaired by a specialist before continuing use.
-
Do not replace any components or modify the construction and design. If the component used is not
the same as that originally supplied by the manufacturer, the manufacturer will not be held liable.
ATTENTION :
This tool meets the corresponding safety regulations. Repairs other than those specified in this
manual should only be carried out by qualified persons.
4.1.
Condensation water
It can enter through the air inlet and damage the tool. To prevent this, it is necessary to drain this water
from your compressor. Air filters should also be cleaned regularly (once a week). After the compressor has
been running for a while, a lot of water accumulates inside the compressor. It must be evacuated regularly
and maintain dry air.
4.2.
Performance of your tool
It is necessary to carry out a little daily maintenance: clean and lubricate regularly. Use only air tool oil.
SODISE 85 Route de Pont Gwin 29510 Briec FRANCE
NIU 06982 V.1.8
21
Publicidad
