BETEX iDuctor 1 Manual Del Usuario página 8

WARNING!
When using the flexible induction inductor and U-inductor it is important to
wind as few turns around the object as possible. Where excessive turns are
wound the current amperage will rise too high and the safety cut-out will trip.
The optimal number of turns will vary between objects. Start with a single turn
and gradually increase the number of turns as necessary.
WARNING!
If the iDuctor is used in one of the lower power settings it may produce a
ticking sound: this is normal and not a fault.
4�2 Rotary switch and push button
The patented rotary switch at the rear of the iDuctor is used to adjust the heating time and
power. These adjustments should be made before you press the push button on top of the
unit to activate heating. The settings can not be adjusted during heating. Once adjustment is
complete the inductor is held around the object to be heated and the button on top of the unit
is depressed. In positions 1 to 5 the unit will switch off automatically after the specified time. In
position 6 the unit will continue to heat until the button is released or the iDuctor is switched
off by the internal temperature safety cut-out. Once the iDuctor has cooled sufficiently the
heating process will start up again automatically when you press the button. The iDuctor is
active when the LED on the front is illuminated.
8 © BETEX Tools