BETEX iDuctor 1 Manual Del Usuario página 9

4�3 LED lighting and fan
The LED on the front of the unit will light up to illuminate the object when you press the
button. The fan will then run to cool the system. The fan will remain active throughout the
heating process and also thereafter if the measured internal temperature is high. Once the
temperature has returned to a normal level the fan will switch off automatically. For this reason
the mains connection should be maintained until the fan stops running. The iDuctor will switch
off (or fail to switch on) if a fault is detected. In that case the LED light will flash when the button
is depressed. (See: "Error messages".)
WARNING!
In order to prevent damage the iDuctor and the inductor must be allowed to
cool thoroughly after use before they are returned to their storage box. Both
the unit and the inductors can become hot in use.
WARNING!
The unit must always be connected to a supply network with a fuse rated at
at least 5A and at most 16A. The unit does not have an internal fuse. An earth
bonded wall socket should always be used on safety grounds (Class I).
WARNING!
The unit does not feature an on/off switch, as soon as the plug is inserted in the
socket the unit will be powered up.
NOTE!
The use of a generator is permissible if it is able to deliver adequate power and the
output delivers clean sinus form voltage in the correct frequency range (50 - 60 Hz).
5. Cleaning and maintenance
The iDuctor is maintenance-free. The housing can be cleaned with a dry cloth.
WARNING!
Do not use a wet cloth or solvents: these can damage the unit or its
operation. Do not use a flexible or fixed inductor if the insulating protective
sleeve is damaged or worn.
© BETEX Tools
EN
DE
ES
FR
NL
9