Publicidad
CUB-8
FEATURES CONTINUED
7
EXTERNAL SPEAKER
IMPEDANCE
8-16 OHMS
8
7 – SAFETY WARNINGS –
amplifier.
8 – EXTENSION CABINET –
Recommended suggestions include the CUB-112 and CUB-212 cabinets. If an alternative is used, please note a mismatched
impedance will reduce the amplifiers performance and in some cases may cause damage to your amplifier. When an external
loudspeaker is connected, the Onboard loudspeaker will be muted.
9 – SERIAL NO –
10 – POWER SOCKET –
11 – MAINS FUSE TRAY –
damage in the event of fault by disconnecting the mains power supply. USE ONLY THE CORRECT SIZE AND RATING
SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same size and rating is installed which in turn
blows, the amplifier has suffered a malfunction and needs immediate service from a qualified technician. DO NOT TRY A
FUSE OF HIGHER RATING - Using a fuse that is too large in current rating may cause serious, irreparable damage to the
amplifier and presents a serious fire hazard. The mains fuse ratings are detailed in the Specifications section of this manual,
as well as printed on the rear of the amplifier. There is a spare fuse located in the fuse drawer of the mains power inlet in the
event of a failure.
Always switch off and disconnect the power cord when not in use.
DESIGNED & ENGINEERED IN THE UK
SN: ABC1234567890
BY LANEY ELECTRONICS LTD
Please adhere to the warnings for your safety and the prolonged operation of the Cub-8
Using a good quality speaker cable, connect an external cabinet (8-16 Ohm) here.
Displays the model details and serial number of the unit.
Connected the supplied IEC power cord here.
This drawer contains the main safety fuse for the unit. The fuse protects the amplifier from
MODEL: CUB-8
9
~100V
T500mA L 250V
~120V
~220V
~230V
T250mA L 250V
~240V
SUPPLY VOLTAGE
50 WATTS 50/60Hz
MAXIMUM POWER CONSUMPTION
CAUTION - RISK OF ELECTRIC SHOCK DO NOT OPEN
ATTENTION - LE RISQUE DE DÉCHARGE ÉLECTRIQUE NE S'OUVRENT PAS
10
11
4
Publicidad
