Publicidad
CUB-8
FEATURES
POWER
1
–
1
POWER SWITCh
warm up and be ready to play after switching on, this is normal.
–
2
POWER INDICATOR
The tone control works in a similar fashion to the Tone control you probably have on your guitar except that it
–
–
3
TONE
uniquely works at the other end of the amplification chain. This has the ability to not only control the overall top end response,
but also reduce upper end harmonics on the output stage and preamplifier overdrive sounds. This will give you bright cutting
sounds at high settings and smooth rounded sounds at lower settings. (Midway (5) is a good starting point).
–
–
4
VOLUME
sound and feel, that only a quality tube amplifier can deliver. Now use your guitar volume to control the amount of distortion.
–
–
5
LO INPUT
designed for full range clean sounds
–
–
6
HI INPUT
has a restricted low frequency range to avoid a "mushy" sound from high output guitars.
Experiment with both inputs to find your best sound. To avoid poor sound only use good quality guitar cables.
2
Main power switch for the unit. Tube amplifiers take between 30 seconds and 2 minutes to
–
This lamp will illuminate once the amplifier is switched on.
–
Sets how loud the amplifier is. Try cranking it up a little to drive the power tube harder for that real retro
'LO' stands for low gain. This input is attenuated down approximately 50% from the 'HI' input and is
'HI' stands for high gain. This input is designed to enable the amplifier to be overdriven more easily and
TONE
VOLUME
3
4
INPUT
LO
HI
5
6
3
Publicidad
