Adjustment Instructions - HIKOKI UU 240F Instrucciones De Manejo

WARNING
To reduce the risk of serious personal injury, turn off and
disconnect the machine from power source outlet before
installing and removing mounting brackets, making
adjustment or doing repairment. An unintentional start-up
can cause injury.

ADJUSTMENT INSTRUCTIONS

ADJUSTING THE EXTENSION SUPPORTS (FIG. L)
The extension support assembly helps keep the
workpiece level and stable during cutting operations.
1. Loosen the lock knob (1) and slide the extension arm
to the desired length. Tighten the lock knob (1).
2. Loosen the height adjustment knob (2) to adjust the
extension support assembly (3) to the desired height
and then tighten the knob (2).
3. Repeat for the other extension support.
4. If repetitive cutting is required, loosen the plate
adjustment knob (4) to adjust the work stop plate (5)
to the desired height, and then tighten.
Fig. L
3
1
ADJUSTING THE SAW MOUNTING BRACKETS
(FIG. M)
If the saw mounting brackets can slide over the top rails
or be removed from the top rails when the bracket cam
latches (1) are locked, the bracket adjustment screws (2)
need to be tightened. If the saw mounting brackets will
not fi t over the top rails, the bracket adjustment screws
need to be loosened.
ADJUSTMENT
5
4
2
NOTE: The miter saw should be removed from the
mounting brackets before attempting to tighten or loosen
the bracket adjustment screws (2).
1. Loosen the lock nut (3) using a 10 mm wrench.
2. Turn the adjustment screw (2) by using a Phillips
screwdriver. Turn the screw clockwise to tighten the
bracket, and turn counterclockwise to loosen it.
NOTE: If the cam latch of the saw mounting bracket
cannot easily be pushed down into the lock position,
the adjustment screw is too tight. Do not force
the cam latch into the lock position. Loosen the
adjustment screw (2) to adjust it.
3. Press the locking button (4) and lift up the cam
latch (1) so the front holding clamp is fully extended.
4. Install the rear holding clamp on the back rail of the
stand, then lower the front holding clamp over the
front rail of the stand to seat the bracket fully over the
rails.
5. Lock the bracket into place and make sure there is
no movement.
Ensure the saw mounting brackets is placed
perpendicular to the top rails to prevent causing potential
loosening of the adjustment screw when perform cutting
operation.
6. When the tension adjustment is completed, tighten
the lock nut (3) to secure.
7. Repeat the above steps for the other saw mounting
bracket.
Fig. M
2
3
– 16 – – 16 –
WARNING
4
1