Steelcase Migration SE Instrucciones De Uso página 14

_______________________________________________________________
Configuring memory positions
Press the "Up" or "Down" button until the

desired height is reached.
The display indicates the desktop height
=
(e.g. 73 cm).
 Press the "SAFE" button.
Press the desired "Memory position"

button (e. g. button "2")
The display indicates S 2.
=
The display indicates the desktop height
after roughly 2 seconds.
Calling up memory positions
 Press and hold the corresponding memory
position button (e.g. button "1" or button
"2", etc.)
The desktop is moved until the stored
=
desktop height is reached. The desktop
movement is stopped whenever you release
the button before the memory position has
been reached.
EN
Limiting height adjustability
These settings could limit the desktop
movement range (should there be a rolling
file cabinet under the desk or a set of
shelves above it).
The stopping positions for the rolling file
cabinet become the new bottommost end
position, the shelf stopping position and the
new topmost end position.
Move the desktop to the lower halve or the

upper halve of the movement range.
Press and hold the "SAFE" button for 10

seconds
The position is being saved.
=
14
Operating and adjusting
Changing the displayed unit – CM / INCH
Simultaneously press and hold the buttons

"1", "2" and "Up" for three seconds; then
release the buttons.
The letter S and a number (e.g. S 7) are
=
indicated on the display.
Press and hold the "Up" button until S 5 is

indicated on the display.
S 5 is displayed.
=
Press the "SAFE" button.

If the display was previously set to
=
centimetres (cm), it will now be switched
over to inches (inch) and vice versa.
Resetting to factory settings
This function can be used to reset the DM
system to its factory settings.
Press and hold the buttons shown below for

3 sec.:
a Press buttons "1" and "2" and the
b "Up" button
The letter S and a number (e.g. S 4) are
=
shown on the display
Press the "Down" button until S 0 is shown

on the display.
The display indicates S 0
=
 Press the "SAFE" button.
The DM system has been reset to its factory
=
settings. A manual desktop reset may be
required.
153310