Steelcase Migration SE Instrucciones De Uso página 16

_______________________________________________________________
Table of error messages with the Memory control panel
Signal/Code
HOT
ISP
CON followed by
ERR
ERR followed by
ERROR NUMBER
Signal/Code
1
2
EN
16
Message
The overheating protection circuit has
been activated.
The system has detected a collision.
The system has detected a connection
error.
An internal error has occurred.
Message
Firmware error
Overcurrent with motor
Errors and malfunctions
Required measure(s)
Wait until the overheated components have cooled down.
Release all buttons and wait until the drive back function
process is completed.
Release all buttons and wait 5 seconds. Try again.
Disconnect the power supply from the mains.
Then disconnect the system from the power supply. Re-con-
nect the DM system and use it as usual.
Read the table below to determine the correct corrective
measure for the indicated error code.
Required measure(s)
Disconnect the power supply from the
mains.
Then disconnect the system from the
power supply.
Re-connect the DM system and use it
as usual.
Release all buttons and wait 5 seconds.
Try again.
153310