KETRON SD1000 Manual De Instrucciones página 54

3xh 33h Chorus/Flanging feedback, 0 to 7Fh
3xh 34h Chorus/Flanging/Short-Delay high pass filter on input: 0 = no filter to 1.2 kHz
3xh 35h HDAMP: high frequency filter on delay feedback, , 0 to 7Fh = 0 to 100 %
3xh 36h Modulation rate: 0 = ~0,023 Hz, ...64=~0,89Hz, till 127 = ~5,8 Hz (~1Hz to ~20Hz for
Tremolo)
3xh 37h Modulation depth, 0 to 7Fh
3xh 38h Tremolo modulation shape: 0 = triangle, till 127 = square
3xh 39h Rotary speed: 0=slow, 1=fast (only for Rotary preset # 23)
Insert MFX Delay Controls
3xh 58h Delay Preset, 0..4 (off, mono1, mono2, stereo1, stereo2)
3xh 59h Delay ON/OFF, 0 = OFF, else ON
3xh 5Ah Delay Mode, 0=mono, 1=stereo
3xh 5Bh Delay PreLP, 0 to 7Fh
3xh 5Ch Delay Level, 0 to 7Fh
3xh 5Dh Delay Time, 0 to 7Fh = 0 to 1365ms
3xh 5Eh Delay Feedback, 0 to 7Fh
3xh 5Fh HDAMP: high frequency filter on delay feedback, , 0 to 7Fh = 0 to 100 %
Some presets have been predefined for each of the 5 Insert Effects blocks: Compressor, , Distortion, Mod-FX
(Chorus etc) and Delay. Presets are selected through MIDI NRPN messages.
1.2 Compressor/Limiter Presets
Preset is selected by using MIDI NRPN 3x40h, with value = preset number, from 0 to 8
Nb
0 NO COMPRESSION
COMPRESSOR
1 COMPR 1: -18dB 2:1
2 COMPR 2: -15dB 3:1
3 COMPR 3: -18dB 5:1
4 COMPR 4: -21dB 7:1
5 COMPR 5: -24dB 12:1
LIMITER
6 LIMITER 1: -6dB
7 LIMITER 2: -12dB
8 LIMITER 3: -18dB
Notes:
Preset value for Compressor Knee value is always 0 (Hard Knee).
Name
Attack
64
64
64
64
64
64
64
64
64
Preset Default values
Release Threshold
0 127
0 73
0 82
0 73
0 64
0 55
0 109
0 91
0 73
Ratio Boost
0 0
64 24
84 32
100 48
110 48
117 64
127 0
127 0
127 0
2