Optional Accessories - Makita 2705 Manual De Instrucciones

1
► 1. Brush holder cap 2. Screwdriver
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
WARNING:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
Table insert (Part No. 317934-3)
It is required to use this Table Insert for dado head sets.
Use of the standard table insert will interfere with the
dado head set operation.
To install the dadao head set, proceed as follows.
1. Remove the blade guard assembly.
2. Remove the standard table insert.
3. Place riving knife/spreader into the dado position.
4. Install the dado head set according to manufactur-
er's instructions.
5. Place the table insert for dado cutting into the
table.
2
When dadoing, use featherboards. The diagram shown
illustrates dimensions for making a typical featherboard.
It should be made from a straight piece of wood that is
free of knots or cracks.
600 mm
(24")
19 mm
► 1. Kerf should be about 6 mm (1/4") apart
Featherboards are used to keep the workpiece in con-
tact with the rip fence and table as shown, and to stop
kickbacks.
1
► 1. C clamps 2. Facing board 3. Push stick
4. Featherboard
To install featherboards, proceed as follows:
6. Turn the tool off and unplug it.
7. Add 8" high flat facing board to the rip fence, the
full length of the rip fence.
8. Mount featherboards to the rip fence and table as
shown, so that the leading edges of the feather-
boards will support the workpiece until the cut is
completed, and the workpiece has been pushed
completely past the cutter with a push stick.
9. Make sure featherboards are securely attached.
18 ENGLISH
130 mm
115 mm
(4-1/2")
(3/4")
4
200 mm
(8")
1
(5")
2
3