Adjust The Brakes; Adjusting The Chain; Adjusting The Handlebar - Vermeiren Aqua Manual De Instrucciones

3.4

Adjust the brakes

Adjust the brakes according following rules:
3.5

Adjusting the chain

3.6

Adjusting the handlebar

L
CAUTION:
Risk of injury – Check that the handlebar is firmly secure before
using the tricycle.
1. The brake tightness can be adjusted by the
brake cable adjuster .
The wheels of the tricycle are driven by a chain
 on the rear axle.
For first time use the chain  is set in the
factory. After a while it is possible that the chain
 runs off the axle, the chain  has to be
tightened by extending the frame of the tricycle:
On the frame behind the saddle tube you see
two horizontally mounted length-adjustable
tubes.
By unscrewing the clamping screws  on both
tubes, the frame  can be extended. When the
chain between the two chain-wheels can be
moved ± 20 mm, the chain  tension is correct.
After adjusting the frame length, retighten the
clamping screws .
The height and angle of the handlebar can
easily be adjusted.
Adjusting height:
1. Loosen the screw
2. A softly tap on the head of the cone.
3. Adjust the height of the handlebar to a
comfortable position (stepless --
depends on handlebar model).
4. Tighten the screw
Adjusting angle:
1. Loosen the screw
2. Adjust the angle of the handlebar to a
comfortable position (stepless).
3. Tighten the screw
Page 10
2202, 2215
2015-03

.

properly.

.

properly.