SEVERIN MW-7865 Instrucciones De Uso página 22

General information on programming the unit
To ensure optimum results, this appliance uses state-of-the-art electronics.
∙ While a programme sequence is running, the current setting can be called up by pressing the appropriate key. E.g., if during the
microwave programme the
∙ A programme can be interrupted by pressing the
∙ To restart a programme, press the rotary control
Acoustic signal
When any control button is pressed or the rotary control turned, a correct input is acknowledged by a beep signal.
To cancel the signal, press and hold the
Note: Cancelling the beep signal in this way only affects the use of control button or rotary control; the signals indicating programme
sequences will still be active.
To re-activate the signal, press and hold the
General operating sequence
∙ Place the food to be heated in a suitable container. Place the container onto the turntable in the oven.
∙ When food is placed in the microwave, it should be covered to prevent it from drying out. Glass or plastic covers especially designed for
use with microwave appliances are available at most kitchenware dealers.
∙ When using the grill, hot-air or any of the combination functions, do not cover the food to be cooked.
∙ The grill rack may be put directly on the glass turntable with the food itself on the grill rack.
∙ Close the door and set the desired programme.
∙ As the programme is started, the turntable starts to rotate. During operation, the interior light remains on.
∙ If, during operation, the door is opened or the
is evenly distributed), the timer and programme functions are automatically suspended. The programme will automatically resume only
after the door is closed again and the rotary control
∙ Press twice to interrupt the programme.
∙ A 4-beep signal indicates that the pre-programmed cooking time has elapsed; at the same time, the interior lighting switches off
and the display shows 'End'.
∙ Open the door and remove the container with the food.
∙ In order to achieve an even heat distribution through the food, the container should be set aside for several minutes.
Note: If the door is not opened immediately after the pre-programmed operating time has elapsed, a 4-beep signal is heard every 2
minutes.
Note: The following steps are used for setting the cooking time:
0 – 5 minutes : 10-second steps
5 – 10 minutes : 30-second steps
10 – 30 minutes :
30 – 95 minutes :
Cooling-off function:
This microwave oven has an automatic cooling feature.
After any operating time exceeding two minutes, the cooling fan will automatically run for three minutes after the programme stops.
This extends the service life of the appliance, while using very little energy for the fan.
Clock :
Once the unit has been connected to the power supply, the display shows '1:00' and an acoustic signal is heard.
1. Press once or twice to select the 12 or 24 hour display format. The display shows Hr 24 or Hr 12.
2. Turn the rotary control
3. Press . The minute digits are shown.
4. Turn the rotary control
5. Press to fi nish setting the time. The symbol ': ' fl ashes and the correct time is shown.
The time setting process can be cancelled by pressing the
The clock must be set when the appliance is connected for the fi rst time, and also if a power failure has reset the clock.
22
key is pressed, the display will show the selected power setting.
button for three seconds.
button again for three seconds.
key is pressed (e.g. to stir or to turn the food in order to ensure that the temperature
1-minute steps
5-minute steps
to set the correct hour value.
to set the correct minutes.
Operation
key.
.
is pressed.
key.