Dimmer Function - Hama 00121948 Instrucciones De Uso

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
1. Explanation of Warning Symbols and Notes
Note
This symbol is used to indicate additional information
or important notes.
2. Package Contents
• 1x 433 MHz radio-controlled socket
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial
use only.
• Protect the product from dirt, moisture and overheat-
ing, and only use it in a dry environment.
• Do not operate the product outside the power limits
given in the specifications.
• Do not connect units in series.
• Do not cover when in use.
• There is voltage running through the socket unless it
is unplugged
• Do not continue to operate the device if it becomes
visibly damaged.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to qualified experts.
• Keep this product, as all electrical products, out of the
reach of children!
4. Connecting and getting started
Pug the radio-controlled socket into a standard earthed
socket.
To test the radio-controlled socket and for manual use
without a remote control press the "On" and "Off"
button. When you press the button, the LED of the
radio-controlled socket should light up. When you press
the button again, the LED goes out.
2
Note
Please note that the maximum transmission range
can only be reached under optimum conditions. This
range may be reduced by walls or other radio signals
(mobile phones, WLAN), for example.
5. Learn function of the radio-controlled socket
Press and hold the "LEARN" button for approx. 3 seconds
until the LED starts to blink. Then select the desired
channel by pressing the corresponding "ON" button. The
LED on the radio-controlled will stop blinking when it has
successfully learnt the frequency.
If the learning is unsuccessful, the remote control socket
will leave learn mode after 15 seconds. In this case,
repeat the process. It is also possible to assign a channel
multiple times (multiple radio-controlled sockets can
respond to the same remote control button).
If you wish to delete a programmed channel, first press
the "LEARN" button until the LED flashes. Press the
"OFF" button for the channel to remove its programming.

5.1 Dimmer function

Once the radio power outlet has been trained to recog-
nize the remote control, you can use it to dim lights (only
incandescent bulbs and high-voltage halogen lamps from
40-300 W).
To start the automatic dimming process (brightness is
continuously adjusted), make sure the device is switched
on and then press the "on" button on the remote
control. Once the desired brightness is reached, stop the
dimming process by pressing the "on" button again. This
confirms the set brightness, which will be retained each
time the device is switched on. If you require a different
brightness, start the dimming process again.
Note
Only for use with dimmable incandescent bulbs and
high-voltage halogen lamps (AC 230 V) in the range
of 40 to 300 W (ohmic load). Transformers, LED
lamps, energy-saving lamps and fluorescent lamps
cannot be dimmed.