Peavey DIGITOOL MX16 Manual De Usuario página 23

MEtErS:
As described in the mute button section above, the top row of meters display the input level of the
eight inputs in the MX16 and LIVE. On the MX32, the input/output select button determines the
function of the meters and mute buttons. When inputs are selected (green LED labeled "Inputs" is lit),
all 16 inputs are simultaneously displayed. When the yellow "Outputs" LED is lit, all 16 outputs are
displayed.
The input meters indicate the signal level after analog to digital conversion. The input processing does
not affect the meter reading. The meter aids in setting the hardware input sensitivity and is referenced
to digital full-scale (the input clip point) of the converter. The "0" LED illuminates a couple of dB prior
to the onset of clipping to give a warning in advance of actual clipping. The input meter is not affected
by the input mute.
The output meters indicate the signal level just prior to conversion from digital to analog. All processing
within the Digitool will be reflected in the meter level. However, the MAX OUTPUT LEVEL, HARDWARE
control does not affect the meter. The meter indicates the approximate signal level below the max
output level set in hardware. The "0" LED illuminates a couple of dB prior to the onset of clipping to
give a warning in advance of actual clipping.
uSB Port:
This port can be used for connection to a computer for external setup and control of the Digitool.
A program for setting and controlling the Digitool is available as a free download on line at http://
aa.peavey.com/download/. Instructions for download and installation can be found on this site.
DIGItooL BaCk PaNEL:
Power Inlet: IEC inlet 100-240 VAC 50/60 Hz
auDIo INPutS:
All of the Digitool audio inputs are balanced. The input sensitivity can be adjusted in the Input menu
®
under the HARDWARE function. The sensitivity is continuously adjustable from line level to mic. +48
V phantom power can also be enabled on that screen. Remember, it is always a good idea to mute the
input whenever you engage or disengage phantom power. Unbalanced sources can be connected to a
Digitool input by connecting the signal to the (+) input and shield to (-). If a ground reference is needed
for the input source, the shield can also be connected to the ground connection. However, do not engage
the +48 phantom power on inputs with unbalanced sources. This could result in damage to that source.