Peavey DIGITOOL MX16 Manual De Usuario página 25

®
DIGItooL MX16/32/LIVE SPECS
auDIo INPutS:
Circuitry:
Max Input Level:
Max Sensitivity for Full Scale:
Source Select:
Sensitivity Settings:
Input Impedance:
Phantom Power:
Crosstalk:
Common Mode Rejection:
Equivalent Input Noise: (EIN)
ADC Dynamic Range:
auDIo outPutS:
Circuitry:
Maximum Output Level:
Max Output Level Settings:
Output Impedance:
DAC Dynamic Range:
I/o CoNNECtorS:
MX16 & 32:
LIVE:
aNaLoG INPut to outPut:
Total Harmonic Distortion:
Frequency Response:
Latency:
MEtErING:
Sixteen 5-Segment Arrays:
Meter levels (dBFS):
DIGItaL:
Internal Sample Rate:
AES Input:
Delay:
CoNtroL:
Serial (RS-485):
EtHErNEt:
USB:
CV Inputs:
GENEraL:
Dimensions:
Shipping:
Net Weight:
AC Power Input Voltage:
Power Consumption:
Balanced
+24dBu (determined by sensitivity setting)
-40dBu
Mic/Line, AES-R (even channels), AES-L (odd channels)
-39 dBu to +24 dBu in ½ dB steps
24 dBu to -6 dBu sensitivity setting = 10K Balanced (LINE)
-7 dBu to -40 dBu sensitivity setting = 2.2K Balanced (MIC)
+48V, enabled per channel
Better than 70 dB (@ 1k Hz)
Better than 70 dB (@1k Hz)
-124 dBu 150 Ohm source. 22 Hz to 22 kHz un-weighted
109 dB un-weighted
112 dB A-weighted
Enhanced servo balanced.
+24 dBu (determined by output level setting)
24 dBu to +24 dBu
100 ohms, balanced, 50 ohms unbalanced
110 dB un-weighted
113 dB A-weighted
Euro plug 3.81mm (0.150") Pluggable terminal block
XLR, Pin 2 Hot
< .01% Input to Output, one channel assigned, 22-22k Hz BW
10Hz to 20kHz +/- 0.5% dB
1.7 msec (analog input to analog output)
8 input and 8 output MX16/LIVE
16 input or 16 output (switchable) MX32
-36 dB, -24 dB, -18 dB (GREEN); -12 dB (YELLOW); 0 dB (RED)
Input levels are taken at the ADC outputs, before the mutes.
Output levels are taken at the DAC inputs, not at the connectors.
(The maximum output level adjustment is after the DAC.)
48kHz
Sample rate converted. Accepts 24 kHz to 192 kHz sample rates
Up to 2.5 Seconds on every input and output with 20.8 uS resolution.
Distance calculation on delay screens based on speed of sound=1130 ft/Sec
Half-Duplex 57.6 kBaud, 1 port with 2 multiple drop RJ-45 connectors.
+15V, 250mA power is provided on the connector. (+15V pin 4, Gnd pin 5) If more power is required,
it must be externally sourced.
10BaseT/100BaseT, address is DHCP or Static
2.0 Full speed, "B" connector
0 to 10V with an external voltage applied, or remote passive potentiometer
19" W x 13.125" D x 3.5" H (48.26cm x 33.34cm x 8.89cm)
22.5" x 21" x 6.625" carton, 15 lbs
11 lbs. (5 kg)
100 VAC to 240 VAC, 47Hz to 63Hz universal power supply
20Watts (MX16/LIVE), 35Watts (MX32)