SEVERIN SM 9685 Instrucciones De Uso página 11

- before cleaning the appliance.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Before using for the fi rst time
Remove any packaging materials and check
that all components are present.
Before the appliance is used for the fi rst
time, or after extended periods of non-use, it
should be thoroughly cleaned as described
in the section Cleaning and care.
Operation
We recommend the use of long-life low-fat
milk (UTF, 1.5% fat content). For best
results, the milk should be taken from the
refrigerator immediately before frothing.
The underside of the container and the contact
area on the inside of the base must be clean
and dry.
Choosing the stirring head
∙ Use the smooth stirring head to heat up
milk.
∙ For frothing and heating milk at the same
time, use the serrated head.
∙ For cold-frothing milk, also use the
serrated head.
∙ When not in use, the stirring heads
may be safely stored at the rear of the
housing.
Fill amounts
∙ Always observe the minimum mark and
ensure the container is fi lled with at least
120 ml milk.
∙ For frothing, fi ll the container to a
maximum of 350 ml (lower max mark
∙ For heating, fi ll the container to a
maximum of 700 ml (upper max mark
Heating up or frothing milk
1. Place the container onto the base.
2. Remove the lid from the milk container.
3. Place the appropriate head onto the
mounting protrusion inside the bottom
of the container.
4. Put the required amount of milk into the
container.
5. Place the lid and insert on the container.
6. Insert the plug into a suitable wall
socket. A beep signal is heard and the
65° C indicator starts fl ashing.
7. Use the temperature selection button
to set the desired temperature or the
cold-frothing function (blue dot symbol).
Then press the On/Off switch.
After a beep signal is heard, the
indicator light for the selected
temperature function shows a steady
light and the cooling system of the
motor is heard to start up.
A moment later, the appliance starts to
stir the milk. Once the milk is suffi ciently
hot or the cold-frothing process is
complete, both heating and stirring
processes stop automatically.
The indicator light for the selected
temperature function fl ashes, and a
number of beep signals are heard.
8. You can now remove the milk container
from the base. Use a suitable spoon to
take off the milk froth.
The cooling system continues to run for
a brief period.
The temperature indicator lamp stops
fl ashing after about three minutes. The
).
).
11