Instructions Manual - brennenstuhl RC 3600 Manual De Instrucciones

Instructions manual

Operating Instructions
Power Supply
Transmitter: A23 battery, 12 V
Switching receiver: 220 - 250 V~, 50 Hz
Max. Resistive Load:
Switching receiver ON/OFF: 3600 Watt / 16 Ampere
Buttons on the Switching Receiver:
Large button on the front of the housing: ON/OFF
Small button on the bottom of the housing: Learn
the coding
Learning the Codes:
1. Push »Learn«- button for 2 seconds so that the
green indicator lamp on the front illuminates and
the receiver is in learn mode.
2. Then push the ON button A of the transmitter to
allocate one of the channels of the remote con-
trol to this receiver.
3. As soon as the receiver has received the valid
code from the transmitter, the display illuminates
3 times to indicate that the code is stored.
4. The learn mode takes approx. 8 seconds, after
which the learn mode has finished, the indicator is
off and the switching receiver is ready for operation.
5. The codes are permanently stored, also if the
switching receiver is not connected to the mains.
6. There are 16.777.216 different codes available for
the system that can be attributed at random.
7. To program further switching receivers, do steps
1 - 4 again with the channels B - C.
6