Hama 00121958 Instrucciones De Uso página 4

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Package Contents
• Radio wall switch
• A23 battery
• two adhesive strips
• These operating instructions
2. Safety Notes
• Repair work may only be performed by qualified
experts or a specialist retailer
• Use the device in dry rooms/indoors only.
3. Getting Started
Note
This remote control is intended as a secondary
or replacement remote control for Hama radio-
controlled sockets. It cannot be guaranteed that
it will work with radio-controlled sockets of other
manufacturers.
Open the battery compartment by removing the two
rockers.
Insert the included battery into the battery compart-
ment. Note the polarity marked in the battery com-
partment. Then carefully press the two rockers back
into the switch housing until they snap into place.
4. Learn function of the radio-controlled socket
See the operating instructions included with the
radio-controlled socket for details.
5. Troubleshooting
5.1 Remote control does not work
Check whether the battery has been inserted with the
poles facing the proper directions. You can check this by
making sure that the label on the battery corresponds to
the polarity marked inside the battery compartment.
2
5.2 The radio wall switch cannot be switched
on or off even though the remote control is
working properly
Check that the socket in question is of Hama make
and is equipped with the learn function.
Repeat the steps above under "Learn function of the
radio-controlled socket" and, if necessary, contact
Hama technical support or the retailer where you
purchased this product.
6. Mounting
Note
The texture of the mounting surface is crucial for
the adhesion of the double-sided adhesive strips.
Ensure that the surface is stable, dry, and free
of dust and grease. It is not advisable to apply
adhesive strips to vinyl wallpaper, polystyrene, or
non-stick, silicon or teflon coatings. Please use
appropriate rawlplugs and/or screws (not included
in delivery) for this purpose instead.
• Remove one of the foils from each double-sided
adhesive strip.
• Place the two adhesive strips on the rear of the
mounting plate.
• Firmly press the adhesive strips on for about 10
seconds.
• Remove the other foil from each double-sided
adhesive strip.
• Place the mounting plate on the wall in the intend-
ed mounting position.
• Firmly press the mounting plate to the wall for
about 10 seconds.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
8. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.