Ideal Heat Elite Plus LCD Manual De Funcionamiento página 8

OPERATION
USA
STAND-BY mode / COOL DOWN DEVICE mode
The STAND-BY mode is used to minimize the energy consumption and reduce the noise
level. It is recommended to cool down the Heat Elite Plus LCDat the end of each working
session.
Example:
4 0
Operation
ACCESSORIES
The following adapters are recommended for the Heat Elite Plus LCD:
Reduction Adapter
Ø 20 mm
Cat. No. 46-950
Welding Adapter
Cat. No. 46-952
• Only genuine IDEAL INDUSTRIES, INC. adapters may be fitted onto the Heat Elite Plus LCD.
• When fitting a adapter, it is strongly recommended to switch off the Heat Elite Plus LCD.
• Attention: Do not touch the adapters, they are hot! Always use pliers!
• Any hot item must be placed on a fire proved surface (example: a metallic sheet) to
avoid danger of fire.
8
410
Press
briefly
Temperature is
being reduced
Glass Protection
Adapter
Cat. No. 46-951
Overlap Welding
Adapter
Cat. No. 46-955
TA -BY
4 0
Press
briefly
Temperature is being
regulated at minimum
air volume
Wide Slot Adapter
Cat. No. 46-954
Pressure foller
Cat. No. 46-956
4 0
Press
briefly
Operation
Small Deflector
Adapter
Cat. No. 46-941
Solder Reflector
Adapter
Cat. No. 46-953