Cleaning And Storage - Hkoenig MXK30 Manual De Utilización

USEFUL TIPS
For the best results when blending solid ingredients, place small portions of the ingredients in the glass
jar a little at a time instead of putting a large quantity all at once. For example, if you want to blend carrots,
you should add some water into the glass jar at the same time. And the ratio of quantity of carrot and water
is2:3. That is to say, if you want to blend the maximal capacity of mixture of carrots and water, the carrots are
not more than 600g, and the water is about 900g (0.9L).
- If you are blending solid ingredients, cut them first into small portions (1.5-2cm).
- When blending solid ingredients, start by adding a small quantity of liquid. Gradually add further
quantities of liquid through the lid opening.
- Always hold the blender top steady with your hand while the appliance is operating.
- Proceed carefully when blending thick liquids.
- To blend solid ingredients or very thick liquids we recommend you use the "Pulse" setting to prevent the
blades from sticking.
- If you want to crush ice, the quantity of ice in glass jar is not more than 12pcs, and size of the ice is not
more than 20*20*20mm.
CAUTION
If the glass jar is filled too much ingredient, the blades may not spin freely thus preventing the blending
cycles from operating correctly. If this happens, switch off the unit and unplug from the socket. Empty some
of the contents and then switch on again.

CLEANING AND STORAGE

Warning: Switch off the unit and then unplug the power
cord before cleaning to prevent electric shocks and other
hazards.
1. In addition to this, you should read the "Safety
precautions"
instructions.
2. Do not clean the motor housing, the power cord or the
plug with water.
3. Clean the motor housing with a soft, damp cloth and
wash with a mild detergent.
4. Half-fill the glass jar with hot water and a small amount of
washing liquid. Leave the unit to operate at maximum
speed until the glass jar is clean (maximum 1 minute).
5. You know the jar base can be separated from the glass
jar, you can turn the jar base in a counter-clockwise
direction and remove the blade assembly together with
the rubber seal. Then you can clean the blade base and
rubber seal with a soft, damp cloth or wash with mild
section at the beginning of these