Panasonic EY74A2 Manual De Instrucciones página 12

Destornillador y taladro sin cables/destornillador y taladro percutor sin cables
Ocultar thumbs Ver también para EY74A2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
Speed Control Function
EN
Setting the maximum speed.
1. Press the speed setting button and select a speed.
The speed changes to H, M, L and OFF (the light is off) in this order.
2. Select OFF to release it.
Display
H
M
L
OFF
• Default setting: OFF
• The speed is the same using either 14.4 V or 18 V when H, M, L settings are selected.
• If a high mode is chosen, the speed is set as the table above.
3 Mode LED Light
Press the light button to select illumination
setting.
Illuminated - Constant
Select by pressing lamp button light
will activate when trigger is pressed.
It will then stay illuminated for
approximately 5 minutes even if tool
is not used but will then switch off
automatically to save power.
Illuminated - On trigger
By pressing the lamp button again,
the mode will move to illumination
upon the pressing of the trigger
only. Will switch off when trigger is
released.
Off
The light illuminates with very low current,
and it does not adversely affect the perfor-
mance or its battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
Low mode
Approx. 300 min
(rpm)
-1
Approx. 200 min
(rpm)
-1
Approx. 150 min
(rpm)
-1
Ordinary speed
18 V Approx. 470 min
14.4 V Approx. 400 min
High mode
Approx. 1000 min
Approx. 670 min
Approx. 500 min
Ordinary speed
(rpm)
18 V Approx. 1580 min
-1
(rpm)
14.4 V Approx. 1350 min
-1
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
Battery Level Indicator
Press the battery level button.
Battery level indicator shows battery level
in three levels while pressing the button.
NOTE:
The indicator will not show the battery
level when the button is pressed in the
following cases.
• The tool is powered off.
• Just after attaching the battery pack
• The main unit or battery level button is
not operated for approx. five minutes.
Press the battery level button again
after depressing the trigger switch.
• If the battery temperature is high, stop
the operation and wait until the battery
temperature is low.
- 12 -
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ey79a2Ey74a2x57Ey74a2pn2g57Ey74a2lj2g57Ey74a2ls2f57

Tabla de contenido