Parker AC10 Serie Manual De Instrucciones página 9

1-7
30kW – 180kW Basic Wiring Diagram for Three-phase AC drives (NPN type)
Keypad
Press "M" key to display function code
Press "Up" or "Down" to select required function code
Press E to read data set in the function code
Press "Up" or "Down" to modify data
Press M to show corresponding target frequency by flashing after saving the set data
Press E to display the current function code
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com
LED shows running frequency, flashing target frequency,
function code, parameter value or fault code.
"DIGIT" (DGT) 4 LEDs indicate working status. RUN while running. FWD
running forward and FRQ when the MMI is showing frequency.
Press "M" for function code, and "E" for original parameters.▲
and▼keys can be used to select function codes and
parameters. Press "E" again to confirm. In the mode of keypad
control, ▲and▼keys can also be used for dynamic speed
control. "I" and "O" keys control start and stop. Press "O" key to
reset inverter in fault status.
English