Using The Hose Extension; Operation Using The 12V Car Cigarette Lighter; Cleaning - Microlife NEB 100 Manual De Instrucciones

2. Pay attention to the position of the arrow when removing and fitting the nebuliser.
3. Please also ensure that the blue nozzle, as shown in the figures, is correctly positioned in the
nebuliser container before you close the nebuliser. A spare nozzle is provided with the device.
4. The nebuliser must be pressed together until there is an audible «click» and firmly pressed into the device.
5. Rotate the nebuliser so that the front is facing you and fit the mouthpiece or face mask.
If possible use the mouthpiece as this gives a better drug delivery to the lungs. However, you may
prefer to use the facemask and you will find two sizes are supplied to suit different size faces. The
mask should completely enclose the mouth and nose areas.
6. Connect the cable from the power supply to the device as shown and connect the power supply to the
electricity supply using the power cord (100 - 230V~ / 50 – 60 Hz).
7. Now switch on the device (I) and place the mouthpiece in the mouth or fit the mask. A green lamp
illuminates above the switch during operation.
8. During the therapy, breathe in and out calmly. Sit in a relaxed position with the upper part of the body
upright. Stop inhalation if you feel unwell.
9. After completion of the inhalation period recommended by your doctor, please switch off the device
and unplug it from the electricity supply.
10. Empty the remaining medication from the nebuliser and clean the device as per the instructions in
this manual.
3.

Using the hose extension

As shown on the foldout page, you can use the hose extension between the device and nebuliser. Put the
device down and conveniently remove the nebuliser from the device for inhalation.
1. To fit the hose extension, please proceed as shown in the figures.
2. Pay attention to the position of the arrow when removing and fitting the connecting piece.
3. Please also ensure that the connecting piece is firmly pressed onto the device and rotated until it is tight.
4.

Operation using the 12V car cigarette lighter

Instead of power supply and power cord, you can also operate the device using the cable for the car
cigarette lighter.
5.

Cleaning

After inhalation the nebuliser should be dismantled as shown and placed in boiling water together with
the mouthpiece for at least 10 minutes. Then place all parts on a clean paper towel and leave to dry.
3