Makita LS0714 Manual De Instrucciones página 20

2. Bevel angle
(1) 0° bevel angle
Push the carriage toward the guide fence and
tighten two clamp screws to secure the
carriage. Lower the handle fully and lock it in
the lowered position by pushing in the stopper
pin. Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower
bolt) on the right side of the arm two or three
revolutions counterclockwise to tilt the blade
to the right.
2
3
003943
Carefully square the side of the blade with
the top surface of the turn base using the
triangular rule, try-square, etc. by turning the
0° bevel angle adjusting bolt clockwise. Then
tighten the lever securely.
1
001819
Make sure that the pointer on the arm point to
0° on the bevel scale on the arm holder. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
1
2
003944
1. Lever
1
2. Arm holder
3. 0 ﾟ degree
bevel angle
adjusting bolt
4. Arm
5
5. Release button
4
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn table
3
1. Bevel scale
3 2. Pointer
3. Screw
(2) 45° bevel angle
003945
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure that
the pointer on the arm points to 45° on the
bevel scale on the arm holder. If the pointer
does not point to 45°, turn the 45° bevel angle
adjusting bolt (upper bolt) on the right side of
the arm until the pointer points to 45°.
Adjusting the position of laser line
For model LS0714FL only
1
3
005701
1
005702
WARNING:
As the tool is plugged when adjusting the position
•
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
Never look into the laser beam directly. Direct laser
•
beam causes damage to your eyes.
Never apply a blow or impact to the tool. A blow or
•
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
20
1. Left 45 ﾟ bevel
angle adjusting
bolt
1
1. Workpiece
2. Cutting line
3. Holder
assembly
(optional
accessory)
2
1. Vertical vise
2. Holder
assembly
(optional
accessory)
2