Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRELIMINARY RECOMMENDATIONS
Unpack the appliance carefully. Keep and
use the original packing in case you return
the product to the retailer one day.
Remove the plastic, the cardboard and the
various protections and other accessories.
Remove the adhesive plastic film protecting
the stainless steel parts before switching
the appliance on.
In the event of a fault please contact the
retailer before use.
Children should be kept away from the pac-
king material (foam polystyrene, plastic
bags, clips, etc.), as it may be very dange-
rous for them.
SAFETY STANDARDS
Check that the supply voltage of the grid
corresponds to that marked on the rating
plate put under the appliance, which must
be earthed and whose circuit in compliance
with the relevant safety standards. In case
the power socket and the plug of the
appliance do not correspond, let the socket
be removed and changed by an authorized
person only.In case you dispose the
appliance near walls and partition walls,
kitchen furniture, decorative elements,
etc., these should be made of antifire mate-
rial in compliance with the fire prevention
standards. Take care to keep a minimum
distance of 25 cm. from the surrounding
elements (50 cm from the top). In the event
of damage, the power cord should be
removed and replaced by an original one.
USING YOUR TOASTER
This conveyor toaster is ideal to toast slices
and bagel by radiant heat. The toasting of
coated products such as a garlic bread and
cheese sandwiches is not recommendet.
Any other use of the appliance is improper
and dangerous. Use original parts and
4
ENGLISH
accessories only. Do not leave the working
appliance unattended. Keep children and
unauthorized
people
away
appliance. Do not use it outdoors and do
not expose to damp. Do not soak or sprin-
kle it in water or any other liquid. Avoid cle-
aning the appliance with liquids, as it is not
waterproof. Do not place anything on top
of the toaster.Do not cover the appliance:
otherwise, risk of fire!. Disconnect the plug
when the appliance is switched off.
Disconnect the plug before moving the
appliance.
Do not tear the power cord or the applian-
ce by disconnecting the plug from the
power socket. Avoid any contact between
the power cord and the appliance. Risk of
burn! Cool the appliance off before moving
it.
First Use or Reuse of the Appliance after a
long Period of Idleness.
1. Use the appliance in airy spots.
2. Check position of crumb tray (5) and
toast collector (7).
3. Connect the power plug with the socket.
4. Select the lighting switches.
5. Set speed (2), top heating (3), bottom
heating (4).
6. On for about 40 minutes.
HOW TO USE YOUR CONVEYOR TOASTER
Warning: The thickness of bread to be put
in the heating chamber should not exceed
5 cm (2,in.) for model ST-252.
1. Check position of crumb tray (5) and
toast collector (7).
2. Connect the power plug with the socket.
3. Turn the lighting switches on.
4. Set speed (2), top heating (3), bottom
heating (4) to medium position
5. Load up.
the model ST-252 the conveyor feeder
guide can be used in two position.
When in the upright position, the toaster is
set for autotatic feed. Bread slices enter tje
toaster simply by placing them on the fee-
der guide and rekasing. For manual feeding
from
the
of bread, tip the feeder guide until it rests
on top of the toaster. In this position, slices
can be manualy loaded by placing them
directly on the conveyor belt.
6. output / discarge
the model ST-252 can be set up so the
bread discharges at the either the front or
rear of the unit.
For front discharges, install the toast
collector (7) in the front of the unit as
shown in figure. Place the back panel (8) as
shown in figure. For rear discharge, install
the toast collector (7) and the back panel
(8) on the rear and as shown in figure.
RECOMMENDATIONS FOR USE
Allow approximately 15 minutes for a
warm up period.
The time necessary to reach the right bread
and food cooking point depends on several
factors: quality, freshness, thickness,
shape, food and stuffed food temperature.
The right cooking point can be reached
after several tests, also considering that:
- when the appliance is cold, cooking time
should be increased;
- food cooked in this appliance can be very
hot - handle with care.
- don't block cool air flow gates on rear
and bottom.
CLEANING
Disconnect the power plug before cleaning
the appliance. Cool the appliance off befo-
re cleaning or moving it. Clean the applian-
ces externally with a damp cloth or special
products for stainless steel . Take the
crumb tray periodically out (5) and clean it
with a damp cloth. On the toaster mod ST-
252, the toast crumb tray can be easily be
removed by sliding it out from the front of
Publicidad
Tabla de contenido
