- in case of any malfunction,
- during cleaning, and
- when refilling, with the reservoir
installed.
●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Anti-scale system
The steam generator is equipped with a
special anti-scale filter which 'softens' the
water and therefore reduces the build-up of
lime deposits in the sole plate. Changing or
replacing the filter is not necessary, as this is
a permanent filter.
Filling with water
- With the special anti-scale system, the
steam generator is not liable to the build-
up of lime deposits.
- Before the steam function can be used,
the water reservoir must be filled with
water as follows:
- Remove the reservoir.
- Open the water filler hole and fill the
reservoir with clean tap water,
observing the 'Max' marking on the
reservoir.
- Close the water filler hole and replace
the water reservoir in the steam
generator.
- Once the water has been used up during
ironing, the sound of the pump increases
as air is pumped instead of water. This is
perfectly normal and no cause for
concern. Re-fill the reservoir as described
above. It is not necessary to switch off the
appliance.
General information about ironing
Always check first whether a label with
ironing instructions is attached to the article
to be ironed.
- The meaning of the ironing symbols is as
follows:
•
Synthetics
(low temperature)
••
Silk and wool
(medium temperature)
•••
Cotton and linen
(high temperature)
- These markings can also be found on the
temperature control knob of the iron in
the form of dot symbols.
●
Laundry to be ironed should be sorted
according to the fabric ironing
temperature. Follow the ironing symbols
and start with the lowest temperature.
●
When ironing highly sensitive fabrics, or
if you are not sure about the fabric, you
may carefully test-iron on a non-visible
point, e.g. inside a seam. Always start
with the lowest temperature.
●
If the laundry is put into a dryer before
ironing, the temperature should be
adjusted to 'iron dry'. Very dry fabrics
are difficult to iron.
Start up
Before it is used for the first time, the iron
should be cleaned according to the
9