Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel,
_fyeu have any problemswith the assembly of your
pressurewasher, please caii the pressurewasher heipiine
at 1-800-222-3136.
UNPACK THEPRESSURE WASHER
1,
Remove everything from carton except pressure washer.
2,
Open carton completely by cutting each corner from top
to bottom,
3,
Remove pressure washer from carton,
CARTON CONTENTS
Check all contents, if any parts are missing or damaged, carl
the pressure washer helpline at 1o800o222°3136,
o Main Unit
o
Handle
o Accessory Tray with Hose Wrap
o
High Pressure Hose
o Spray Gun
o Nozzle Extensionwith Quick Connect Fitting
o Oil Pouch
o
Bottle Bracket Wireform
o
PerfectMix
TM
Siphoning Unit/Hose
o
Parts Bag (which includes the following):
o Operator's Manual
o Owner's Registration Card
o
Bag containing 4 Multi-Colored Quick Connect Spray
Tips
o
Handle FasteningHardware Kit (which includes):
o
Handle Bolts (2)
o Carriage Bolt (1)
o
Plastic Knobs for Handle(2)
o
Plastic Knob (1)
•
Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer, identify all contents with the illustration on
page 6. if any parts are missing or damaged, call the
pressure washer helpline at 1o800o222-3136,
ASSEMgLING PRESSUREWASHER
Your Craftsman pressure washer will need assembly before
operation:
1,
Fill out and send in registration card.
2.
Attach handle and accessorytray.
3,
Connect detergent siphon hose to pump.
4,
Add oil to engine crankcase.
5,
Add fuel to fueltank.
6,
Connect pressure hose to spray gun and pump.
7,
Connectwater supplyto pump.
8,
Attach nozzle extensionto spray gun.
9,
Select/attach quick connect spray tip to nozzleextension.
Attach Handle and Accessery Tray
1,
Place handle (A) onto handle supports connected to
main unit, Make sure hobs in handle align with hobs on
handle supports,
2.
insert handle carriage bolts (B) through hobs from
inside of unit and attach a plastic knob (C) from outside
of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle section of
the attachment bolt, the upper handle can fold forward to
store fiat atop the cold engine. DONOTfold the handle down
while the engine is hot.
3,
insert rubber straps (t}) through slots (E) in back of
accessorytray and pull tight from front.
Publicidad
Tabla de contenido
