Using Boost Mode; Using The Aux Input; Auto Power Off - Panasonic SC-NT10 Instrucciones De Funcionamiento

Using Boost Mode

It will make the sound played back on this unit easier to hear by boosting the level
of specific frequency band.
Press [BOOST] of this unit to switch the effect on/off.
• The Boost Mode indicator (orange) lights up.
Note
• If sound is distorted during playback, switch off the "Boost Mode".
• When saving the power consumption, set "Boost Mode" to "off".
• Location of this unit may move due to vibration.

Using the AUX input

You can listen to audio via the AUX IN jack (
device with an audio cable (not supplied).
Note
• When using the AUX input, AUX input has priority than the Bluetooth
(It will be possible to receive a call hands-free by pressing [
in on the device connected with Bluetooth
• The setting of the Bluetooth
into AUX IN jack.
• When using the AUX input, the volume may seem low depending on the connected device. In
that case, check if the volume limit can be changed on the device. For details, refer to the
manual of the device.
• If an audio cable is inserted during audio playback with a Bluetooth
occur. In this case, stop the playback on the device connected via Bluetooth

Auto Power Off

This unit automatically turns off if there is no audio input and no operation is
performed for approximately 10 minutes.
Note
• This function will not operate when the AUX input is used while connected with the USB cable.
• This function may operate even when the music is being played back if the volume of the
connected device is low.
• This function may not operate depending on the connected device.
10
10
®
. 11)
®
is not changed even if the audio cable (not supplied) is inserted
4) when this unit is connected to a
®
features and NFC features.
] when there is a call coming
®
connection, noise may
®
.