Tabla de contenido
Publicidad
CAUTION
the snow thrower, shut off the engine, remove
the spark plug wire(s), set the parking brake
and remove the key from the tractor ignition.
REPLACING AUGER BELT
•
Disengage the tractor's attachment clutch.
•
Lower the snow thrower to the ground.
•
Remove the attachment pin.
•
Lock the snow thrower's lift handle in the down
position to decrease belt tension.
•
Release the spring tension from the auger belt idler
arm on the bottom of the clutch/idler assembly.
•
Remove the auger drive belt from the clutch/idler
assembly and from the spiral auger housing.
•
Install new belt over top of large auger drive pulley
and under the two side idler pulleys. Twist the belt 1/4
turn to seat the "V" of the belt in the groove of each
idler pulley. Refer to figure 55 on page 24.
•
Assemble the belt onto the clutch/idler assembly.
SKID SHOE ADJUSTMENT
•
The skid shoes are mounted on each side of the spiral
auger housing. They regulate the distance the scraper
plate is raised above the plowing surface. When
removing snow from a gravel driveway or and uneven
surface, it is advisable to keep the scraper plate as
high above the surface as possible to prevent possible
damage to the spiral auger. On blacktop or concrete
surface, keep the scraper plate as close to the surface
as possible.
•
Raise the snow thrower off the ground and place a
block under each end of the scraper plate. Loosen the
six hex nuts securing the skid shoes to the housing.
Adjust the skid shoes up or down and retighten the
nuts securely. Adjust both skid shoes to the same
height to keep the housing and the scraper plate level.
See figure 59.
FIGURE 59
SERVICE AND ADJUSTMENTS
: Before servicing or adjusting
LIFT RELEASE CABLE ADJUSTMENT
•
If the lift rod does not lock the snow thrower securely
in the transport position, loosen the upper hex nut on
the lift bracket a few turns and tighten the lower hex
nut. Refer to figure 48 on page 22.
•
If the lift rod fails to unlock completely to lower the
snow thrower, loosen the lower hex nut on the lift
bracket a few turns and tighten the upper hex nut.
Refer to figure 48 on page 22.
CLUTCH DISENGAGEMENT ADJUSTMENT
(For tractors with engagement rod clutches only.
Not for electric clutches or cable clutches)
If the spiral auger on the snow thrower does not stop
when the attachment clutch lever on the tractor is
disengaged, then adjustment is necessary. Proceed as
follows. Refer back to figure 33 on page 17.
•
Place the attachment clutch lever in the disengaged
position.
•
Remove the hairpin cotter from the engagement rod
trunnion and lift the trunnion out of the hole in the idler
arm.
•
Screw the trunnion a few turns towards the front end
of the rod.
•
Replace the trunnion into the hole in the idler arm and
secure it with the hairpin cotter.
Check the operation of the snow thrower. If the spiral
augers still do not stop, repeat the above steps until
the augers stop when the attachment clutch lever is
placed in the disengaged position.
SPIRAL AUGERS
•
The spiral augers are secured to the auger shaft with
two shear bolts and nylock nuts. If you hit a foreign
object or if ice jams the augers, the snow thrower is
designed so that the bolts will shear.
•
If the augers will not turn, check to see if the shear
bolts have sheared. See figure 60. Two replacement
shear bolts and nylock nuts have been provided with
the snow thrower. For future use order part number
710-0890A shear bolt and number 47810 nylock nut.
FIGURE 60
28
Publicidad
Tabla de contenido
