SEVERIN BR 7933 Instrucciones De Uso página 9

●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and is not designed for medical
or commercial applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The addresses can be found in the
appendix to this manual.
Before using for the first time
- Remove the appliance from its
packaging.
- Remove any exterior and interior
packaging materials and make sure that
the dust bag, the motor-protection and
exhaust air filters are correctly inserted.
Thermal safety cut-out
This vacuum cleaner is equipped with an
integral thermal safety cut-out, which
automatically switches the appliance off in
case of overheating (e.g. due to blockage in
the tube or filter). Should this occur, remove
the plug from the wall socket and let the
appliance cool down for a minimum of one
hour. The vacuum cleaner may then be used
again after the blockage has been removed.
Operation
- Put the vacuum cleaner in its horizontal
operating position.
- Insert the hose into the hose connection.
- Connect the tube to the hose grip.
- Attach any of the nozzles provided to the
end of the tube. If the full tube length is
not required (e.g. when using the
upholstery tool), the nozzle may be
attached directly to the hose grip.
- Pull out the power cord from its storage
to the necessary length (but not beyond
the red mark) and insert the plug into a
suitable wall socket.
- The vacuum cleaner is equipped with a
very powerful motor. In order to prevent
a fuse within your home electrical
installation from being triggered at
switch-on, always set the power regulator
to its lowest setting before the appliance
is switched on.
- The electronic suction regulator allows
the suction power to be infinitely
adjusted to your needs.
- In addition, the suction power can be
decreased further by opening the
secondary air-flow opening slide in the
hose grip.
- Always start with a low setting when
cleaning soft objects such as curtains.
●
Always ensure that the power cord is not
routed around or runs over corners or
edges, and that it cannot be jammed in a
door.
- During operation, the hose may be used
to pull the unit along behind you.
However, when carrying the unit, always
use the carrying handle.
●
To prevent the power cord from being
pulled with excessive force, always
change to the next suitable wall socket
when cleaning larger areas.
- Switch off the appliance after use and
remove the plug from the wall socket.
- To retract the power cord automatically
into its storage, press the foot switch of
the retract mechanism.
Accessories
The dual-purpose tool is located in the
accessories compartment.
Multi-purpose tool
The multi-purpose tool is especially suitable
for cleaning large areas.
Upholstery brush
Fold out the brush element of the dual-
6