Kenwood KSC-SW10 Manual De Instrucciones página 6

Altavoz de subgraves con cerrado alimentacion
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
Connecting the subwoofer to the subwoofer (non-fader) output of the center unit
Center unit
RCA cord
(Commercially
available parts)
When the center unit output is a single RCA jack, use an
RCA cord that converts the output into the two RCA jacks
as shown above.
The subwoofer output will be halved if the conversion
cord is not used.
Examples
The following shows a typical connection for effective car stereo enjoyment. Connect your system by referring to the example.
Caution:
Under any circumstances, never ap-
ply inputs to the hashed terminals A
and B simultaneously.
If there is no power control terminal in the center unit, con-
nect the blue/white wire to the accessory line
(ignition key switch ACC position line).
Car fuse box
Ignition key
switch
Car fuse box
(Main fuse)
Battery

English
Front speaker
KSC-SW10
9 RCA cord
POWER/SPEAKER
REMOTE
INPUT
LINE IN
L
R
Fuse 10A
I f buzzing noise is heard from the
speakers when the engine is running,
attach a line noise filter (commercially
available) to the power lead.
Center unit
(SUB WOOFER OUT,
Non-fader output)
Caution:
Connect the black lead wire ground terminal directly with a screw to an unpainted
metal part of the vehicle. Turning the power ON without connecting this terminal is
linked to damage of the stereo system. Be sure to connect it.
Also, painted metal panels etc., are not grounded and will not function correctly. Be
careful.
Connect the subwoofer to the subwoofer output
(non-fader output) or the RCA jacks for the front
output of the center unit.
Notes:
• Read the instruction manuals for the connected components
such as the center unit as well as this instruction manual.
• Please purchase an RCA cord that is commercially available
separately.
Use the provided RCA cord 9 for connection between the sub-
woofer and the separately purchased RCA cord.
• When the center unit incorporates a DSP, connect the subwoof-
er to the subwoofer output (non-fader output) or to the RCA
jacks for the front output. Do not connect to the RCA jacks for
the rear output, as the low-frequency reproduction effect may
be attenuated due to the DSP effect.
Caution:
Cover unused terminals with insula-
tion tape to avoid short circuits.
Blue/White
Yellow
Yellow
6 10-pin connector cord
RCA cord (Commercially
available parts)
9 RCA cord

Publicidad

Tabla de contenido
loading

Tabla de contenido