Preparing The Remote Control; Operating With The Remote Control - NAD L56 Manual Del Usuario

PREPARING THE REMOTE CONTROL

Insert the batteries into the remote control so you can use it to operate the DVD player.
1 Open the battery cover.
2 Insert batteries (AAA size). Make sure to match the + and - on the batteries to the marks inside the
battery compartment.
3 Close the cover.
NOTES ON BATTERIES
• Improper use of batteries may cause battery leakage and corrosion.
• To operate the remote control correctly, follow the instructions.
• Do not insert the batteries into the remote control in the wrong direction.
• Do not charge, heat, open or short-circuit the batteries. Do not throw the batteries into fire.
• Do not leave dead or exhausted batteries in the remote control.
• Do not use different types of batteries together, or mix old and new batteries.
• If you do not use the remote control for a long period of time, remove the batteries to avoid possible
damage from battery corrosion.
• If the remote control does not function correctly or if the operating range becomes reduced, replace
all batteries with new ones.
• If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new
batteries.
• The batteries should last about one year with normal use.

OPERATING WITH THE REMOTE CONTROL

This section shows you how to use the remote control.
Point the remote control at the remote sensor and press the buttons.
Distance: About 23 ft (7 m) from the front of the remote sensor
Angle: About 30° in each direction of the front of the remote sensor
• Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or
illumination. If you do so, you may not be able to operate the DVD player with the remote control.
NOTES ON THE REMOTE CONTROL
• Direct the remote control at the remote sensor of the DVD player.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near extremely hot or humid place.
• Do not spill water or put anything wet on the remote control.
• Do not open the remote control.
Introduction
IDENTIFICATION OF CONTROLS
PRESS IN AND LIFT TAB TO REMOVE BATTERY COVER
OUT OF RECESS
PLACE BATTERIES INTO OPENING.
INSURE THE CORRECT FITTING
IS OBSERVED
REPLACE BATTERY COVER BY ALIGNING
AND INSERTING THE TWO TABS INTO THE
HOLES.
PRESS BATTERY COVER INTO
PLACE UNTIL IT 'CLICKS' CLOSED
GB
11