Section 3: Assembly; Add Engine Oil And Fuel - Troy-Bilt 020241 Manual Del Operario

Section 3: Assembly

2. Insert carriage bolt through left side hole from
outside of unit and attach a plastic knob from
inside of unit (viewing from rear of unit). Tighten by
hand (Figure 2).
Figure 2 — Attach Bolts to Handle
3. Insert "L" bolt through hole on right side of handle
(viewing from rear of unit) and attach plastic knob.
Tighten knob by hand (Figure 2).
4. Insert "L" bolt through hole just above billboard on
right side of handle (viewing from rear of unit).
Hold hook in place and attach a plastic knob from
inside of unit (Figure 2). Tighten by hand.
5. Place accessory tray over holes on handle
(viewing from front of unit). Push the tree clips into
the holes until they sit flat against the accessory
tray (Figure 3).
Figure 3 — Attach Accessory Tray to Handle

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will
result in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
• Refer to engine operator's manual and follow oil and
fuel recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer
to engine operator's manual for recommendations.
8