Assembly & Set-Up; Unpack Pressure Washer - Troy-Bilt FLEX 23AADAAA711 Manual Del Operador

Assembly & Set-Up
Read entire operator's manual before you attempt to
assemble or operate your new pressure washer.
If you have any problems with the assembly of your pressure
washer, please call (800) 828-5500. If calling for assistance, please
have the model and serial number from the identification label
available.

Unpack Pressure Washer

1. Remove the parts bag, any accessories, and cardboard
inserts included with pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Main Unit
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Operator's Manual
• Owner's Registration Card
• Bag containing 5 Multi–Colored Spray nozzles
• Bag containing soap inlet tube with 2 clamps
Set-Up
To prepare this pressure washer attachment for operation,
perform these tasks:
1. Remove the five plastic caps shown in Figure 3-1.
Note: The first four caps pull off as shown. The plastic cap
in the inset of Figure 3-1, rotates counter clockwise to
remove. If choosing not to install the soap inlet tube at this
time, the plastic cap on the soap inlet port of the pressure
washer pump may remain in place.
Soap Inlet
Port
Figure 3-1
2. Locate the bag containing the 5 multi-colored spray
nozzles, included with the loose parts in the carton. Insert
the tips into the provided mounting holes on the pressure
washer main unit. Follow the color pattern provided on
the label on the unit for the proper order in which to install
these tips. See Figure 3-2.
Figure 3-2
3. Connect high pressure hose to spray gun handle by
threading the hose onto the spray gun as shown in Figure
3-3.
Figure 3-3
3
7