White Rodgers Blue 2 Manual De Instrucciones página 5

INSTALLER/CONFIGURATION MENU
Menu Press
Reference Key
Number
and
and
8
and
and
and
and
System Configuration
Select CS (Cool Savings™)
to reduce cooling system running time and save energy.
of run time, the thermostat will start increasing the setpoint
temperature in steps of less than one degree as the system
the system to satisfy the thermostat and turn the system off
occur when the cooling system is continuously running
will normally occur during the late afternoon and early
evening on the hottest days of the summer.
Select Cycle Rate Selection
cycle rate, press the
The cycle rate differentials for different settings are:
MODE
Displayed
(Factory
Default)
L
Temp
o
F
Change Filter
Change Filter
and buttons.
Fast Medium Slow
Press or
to select from
listed options
OFF
4 LO to
lower
o
C
On
If Change Filter selected On, selects time interval for
Returns to normal operation
Select Compressor Lockout CL OFF or ON
cooling cycles. This is intended to help protect the
already have a time delay built in and do not require this
feature. Your compressor manufacturer can tell you if the
setpoint for up to five minutes.
Select Backlight Display
terminal is connected, selecting backlight CdL On will keep
selection, the light will be on momentarily when any key is
pressed.
Select Temperature Display Adjustment 4 LO to 4 HI
higher or lower. Your thermostat was accurately calibrated
at the factory but you have the option to change the display
temperature to match your previous thermostat. The
the display.
Select F° or C° Readout
Celsius or Fahrenheit as required.
Select Filter Replacement Reminder and Set Run Time
On, press
After the selected time of blower operation, the thermostat
will display "Change Filter" as a reminder to change or
press the
restart the time to the next filter change. A selection of OFF
will cancel this feature.
Comments
o o
"Change Filter" reminder On or OFF. If selected
and
"Change Filter" is displayed,
and button to clear the display and