Tank Full/Tank Empty Light; Emptying The Dirty Water Tank - Philips AquaTrio FC7070/01 Manual Del Usuario

5.4 Tank full/tank empty light

The tank full/tank empty light starts
1
flashing and the appliance stops operating
when the clean water tank is empty. Fill the
clean water tank (see chapter 'Preparing for
use', section 'Filling the clean water tank').
The tank full/tank empty light lights up
2
continuously and the appliance stops
operating when the dirty water tank is full.
Empty the dirty water tank (see section
'Emptying the dirty water tank' below).
5.5 Emptying the dirty water
tank
Pull up the lever to unlock the dirty water
1
tank and remove the dirty water tank.
Push the lid unlocking slides forwards (away
2
from the handle) to unlock the lid and remove
the lid from the dirty water tank.
12
Pour the dirty water out. To prevent spilling,
3
always pour out from one of the corners of
the tank.
Rinse the empty dirty water tank and its lid
4
under the tap.
Place the lid back onto the dirty water tank
5
and pull the lid unlocking slides backwards
(towards the handle) to lock the lid.
lift and hold the lever (1) and slide the dirty
6
water tank back into the appliance completely
(2). Press down the lever (3) to lock the
dirty water tank into place ('click'). Make sure
the lever for the dirty water tank is locked
properly. If the lever is not locked properly, the
dirty water tank may fall out during cleaning.