Active Protection System Is Activated - Philips AquaTrio FC7070/01 Manual Del Usuario

5.6 Active protection system is
activated
The active protection system has been designed
to recognise when a foreign object other than dirt
or liquid is picked up from the floor. When the
system is activated, it stops the mopping brushes
immediately to prevent damage to the object and
appliance. The motor sound decreases and the
appliance no longer applies water to the floor. The
active protection system is also activated when
the mopping brushes are too wet or when you
move the appliance over a carpet. To continue
cleaning, follow the instructions below!
Release the power-on button to switch off
1
the appliance (1). Put the appliance upright
in parking position ('click') and pull the plug
out of the wall socket. If the object picked up
is the cord of another appliance, unplug this
appliance as well (2).
Open the mopping nozzle lid (1), remove the
2
mopping brush cover (2) and take out the
object (3). If you cannot find the object, you
can remove the mopping brushes to have a
better look.
If the active protection system was activated
3
because the mopping brushes are too wet,
remove the mopping brushes and squeeze
them over the sink (see chapter 'Cleaning and
maintenance', section ' Cleaning the mopping
nozzle').
Place the mopping brush cover (1) and close
4
the mopping brush lid (2). Press the mopping
nozzle lid (3) to lock it ('click'), otherwise the
appliance is not reset.
Put the plug in the wall socket. Press the
5
nozzle with your foot and release the
appliance from parking position. Push the
unlock slide forwards (1) and press and hold
the power-on button (2). You can release the
unlock slide when the appliance switches on
(3). Keep the power-on button pressed to
continue cleaning.
5.6.1 Important to know
To reset the active protection system you need
to open and close the mopping nozzle lid. Make
sure you always remove any object from between
the mopping brushes before you switch on the
appliance.
13