Maintenance; Storing And Moving Your Aquatrio; Storing Your Aquatrio - Philips AquaTrio FC7070/01 Manual Del Usuario

If the mopping brushes are still too wet,
4
let them dry (see chapter 'Storing and
moving your AquaTrio', section 'Storing your
AquaTrio'). If the mopping brushes are too
wet, they encounter too heavy resistance
and will activate the active protection system
when you switch on the appliance. Make sure
the mopping brushes are dry before you start
cleaning your floors.
6.4.1 Important to know
•
The mopping brush cover cannot be placed
properly if the mopping brushes are not placed
correctly. The mopping nozzle lid cannot be
closed if the mopping brush cover is not placed
properly. The appliance does not work if the
mopping nozzle lid is not closed properly.

6.5 Maintenance

If the outside of the appliance is dirty, clean it
1
with a damp cloth.
When the air inlet is dirty, clean the air inlet
2
with a damp cloth.
Check the ventilation openings regularly to
3
ensure that they are not blocked.
Check the condition of the mains cord
4
regularly to make sure it is safe and
undamaged.
Warning:
B
Do not use the appliance if the mains cord is
damaged. Have the mains cord replaced by an
authorised Philips service centre or take the
appliance to your dealer for repair.
7 Storing and moving
your AquaTrio

7.1 Storing your AquaTrio

To store the mains cord, wrap it around the
1
cord storage hook and the lever for the dirty
water tank.
18
Tip:
E
For easy release and easy access to the water
tanks, you can also wind up the mains cord
and hang it on the cord storage hook. You can
use the cord clip to fix the end of the cord to
keep it in place when the cord is wrapped for
storage.
When you store the appliance, place it on the
2
flushing tray.
If the inside of the mopping nozzle is not
3
yet dry, place the mopping brush cover back
in the mopping nozzle askew and leave the
mopping nozzle lid open. This allows the inside
of the mopping nozzle to dry.