TRAPP TRF 600 Manual De Instrucciones página 46

1 - Shredder plus coupling unit
When purchasing the shredder plus the coupling,
the unit leaves the factory already assembled.
In this case, the installation only consists of
connecting the unit to the tractor, by means of
the three coupling points of the hydraulic system,
followed by placing the respective cardan shaft (6).
Table of belts coupling
Model
TRF 600
TRF 700
TRF 800
Points for fastening the
hydraulic system
46
Installation of Coupling to Tractor
Type Quantity
A-72 4
A-72 4
A-78 6
2 - Separate shredder and
coupling
When purchasing the separate shredder and
coupling, the unit is assembled as follows:
a. Fix the machine (1) on the coupling (2).
b. Replace the handwheel of the shredder by the
coupling pulley (3).
c. Align the pulley of the machine with the
pulley which is assembled on the coupling.
d. Place the belts (type and quantity), as per the
table at the side.
e. Tighten the belts correctly by means of the
stretching device.
f. Connect the unit to the tractor by means of the
three coupling points of the hydraulic system.
g. Place the respective cardan shaft (6).
If required, cut a piece of the shaft.
www.trapp.com.br