TRAPP TRF 600 Manual De Instrucciones página 50

To operate with dry products
(grains):
Place the sealing cover (1).
 
Place the green crop feeder cover (2).
 
Select a suitable strainer (diameters 0,8 - 3 - 5 -
 
12 mm). The resulting product depends on the
diameter of the strainer used.
The dry product is placed in the grain funnel (3),
 
and then forwarded to be processed. The end
product leaves the shredder through the lower
part.
Be careful not to overload the motor. Regulate
 
the grain input adjuster according to the
shredder's capacity to grind and to the strainer
chosen. The regulation of the grain input adjuster
is done in the following way: loosen the wing nut
(4) located underneath the grain input adjuster.
Once the regulator (5) is free, pull in case you
need a bigger opening, and push in case you
need a smaller opening. After regulating, tighten
the wing nut (4).
Attention!
The motor may burn due to overload if an
excessive amount of material is introduced.
50
www.trapp.com.br