Pioneer XDP-30R Manual De Instrucciones página 5

> Before Start > Part Names
14.Play/pause ( ) button
15.Skip ( ) button: Skip to the beginning of the track or
to the previous track.
16.micro SD card slot 1
17.micro SD card slot 2
0 When inserting the micro SD card into the card slot,
insert with the contacts facing up and push in
completely so the card clicks into place.
0 To remove the micro SD card, first unmount it (P28).
After unmounting, push the micro SD card in until you
hear a click and then pull straight out. The micro SD
card may spring out so take care not to lose it.
18.Headphone jack ( ): Connect headphones
compatible with balanced output. (2.5 mm/4-conductor)
19.Headphone jack ( ): Connect regular headphones.
(3.5mm/3-conductor)
0 This unit does not support simultaneous use of the
balanced headphone jack and the headphone jack.
Using both jacks at the same time may result in
damage.
20.Charging lamp: This lights white when charging starts. It
turns off when recharging finishes. If the unit is in a state
that prevents charging, it flashes white. Try charging
again after waiting a while.
21.Power button (Í): Press and hold the power button to
turn the power on. To turn the power off, press and hold
the power button so the "Power Off?" screen is
displayed. You can turn the power off by tapping "Yes".
To turn the display on or off, just press the button.
> Initial Setup > Playback
0 If operation becomes unstable, you can shutdown the
unit by pressing and holding the power button for 10 or
more seconds. Refer to "If operation becomes
unstable" (P28) for details.
22.micro USB port: To charge the unit (P6) or transfer music
files (P8, P11), connect the supplied micro USB cable.
23.HOLD switch: You can lock operations on this unit by
sliding the switch up. When the "Operations while
Holding" (P19) setting is "Enable", the volume dial and
side buttons for play, etc., can still be used.
Advanced Setup | Supplementary Information | Others
En 5