Before Starting Playback; Loading The Batteries In The Remote Control; Approximate Operating Range Of Remote Control; Connecting The Power Cord - Pioneer BDP-330 Manual De Instrucciones

Ocultar thumbs Ver también para BDP-330:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before Starting Playback

Loading the Batteries in the
Remote Control
1
Open the rear cover.
2
Insert the batteries (AA/R6 x 2).
Insert as indicated by the / marks into the
battery compartment.
3
Close the rear cover.
Close securely (a click should be heard).
CAUTION
Do not use any batteries other than the ones specified.
Also, do not use a new battery together with an old one.
When loading the batteries into the remote control, set
them in the proper direction, as indicated by the polarity
marks ( and ).
Do not heat batteries, disassemble them, or throw them
into flames or water.
Batteries may have different voltages, even if they look
similar. Do not use different kinds of batteries together.
To prevent leakage of battery fluid, remove the batteries
if you do not plan to use the remote control for a long
period of time (1 month or more). If the fluid should leak,
wipe it carefully off the inside of the case, then insert new
batteries. If a battery should leak and the fluid should get
on your skin, flush it off with large quantities of water.
When disposing of used batteries, please comply
with governmental regulations or environmental public
institution's rules that apply in your country/area.
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire. It can also reduce the life or performance of
batteries.
22
Press lightly on this
part and slide into the
direction of the arrow.
Insert the negative ()
side first.
Approximate operating range of
remote control
Remote control sensor
STANDBY/ON
30º

Connecting the Power Cord

Only connect the power cord once all equipment
connections are completed.
USB
NOTE
Place the Player close to the AC outlet, and keep the
power plug within reach.
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED.
If you are not going to use this Player for a long period of
time, be sure to remove the AC cord from the AC outlet.
PQLS
30º
23 ft
Remote control unit
To AC IN terminal
To AC outlet

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido