Turn On/Off And Reset Device - Orbis CODITEL 2 Manual Del Usuario

STAFF 1=333800123 2=NULL 3=NULL 4=NULL 5=NULL 6=NULL 7=NULL 8=NULL
9=NULL 10=NULL
If the number is NULL the contact is not defined..
NB: the number ADMIN is entered by default as STAFF with index 1. In the case
of adding a STAFF number which does not appear among the enabled numbers
(user), this will be also be automatically added in the user list.
• Manage SIM card (for admin only)
The enabled telephone numbers are saved in the memory of the device. In case of
reset, this implies the loss of all the enabled utilities. To avoid having to re-enter all the
numbers manually, it is possible to make a backup copy of the sim card through the
following commands, to be given by the administrator only:
STORE
creates a copy in the sim card of all the saved user numbers
RESTORE only restores the numbers previously saved with STORE
Therefore, once all the telephone utilities have been enabled, it is advisable to make a
backup of the phone book.
• Display stored user (for admin only)
To see all the saved numbers, use the command
USERVIEW [start], where [start] indicates the first memory location to be displayed
The numbers will be displayed in blocks of 8. A possible response on the USERVIEW 3
command is:
USERVIEW(3-10)=333123455(1) 392234543 0439879832 (3/64)
Number (1) next to the first number indicates that that number is also a staff number
and is in the first position.

TURN ON/OFF AND RESET DEVICE

• Turn off the instrument:
➢ Hold approximately 10 seconds for either the "1-SET" or "2" until all LEDs off.
During the pression of the key, the output led
green (or yellow) for the first 5 seconds and green/ red for the other 5 seconds.
OPERATION
blinks quickly and the led blinks
- 37 -
User Manual CODITEL 2