Commands To The Instrument - Orbis CODITEL 2 Manual Del Usuario

• Turn on the instrument without reset
➢ Press "2". The LED
(or yellow), indicating the correct reception of the GSM signal.
• Turn on the instrument with reset
➢ Press the "1-SET". The input and output leds will illuminate for a few seconds;
waiting for they go out and press "1-SET" key.
The LEDs will flash simultaneously a pair of times indicating that the reset occurred.
Note: The reset erases all data, settings and users stored tool and restore
factory defaults (see box on).

COMMANDS TO THE INSTRUMENT

The two relay outputs can be piloted in the following ways:
− with the keys on the front panel
− via ring or text message from an enabled number
− following an alarm in one of the inputs present
Commands from ring or text message
The outputs can be commanded from a distance via a text message or a telephone ring.
The structure of a text message is as follows:
[password] [separator] [command] [parameter1] [separator]..[parameterN]
[password] 
[separator] 
[command] 
[parameter] 
The password field may be omitted if the command is given by qualified number.
Several commands may be included in one text message. In this case, the
commands executed will only be those whose reply is contained in a standard
text message (160 characters). To enter numbers with the decimal separator, you
need to use a full stop.
The structure of a reply to a command is similar to the command itself, with the addition of
the "=" symbol to indicate the current status. For example:
OUTKEY BLOCK  OUTKEY=BLOCK
will be green initially fixed and then begin to flashing green
numerical field of a maximum of 8 figures
comprised of one or more space characters
command recognised by the device
series of parameters relative to the command
- 38 -
User Manual CODITEL 2
where: