Whirlpool GCAM2792TQ0 Instrucciones De Instalación página 4

Now start...
IMPORTANT: T HISPROCEDURE MUSTBE
FOLLOWED TO ASSURE PROPER
INSTALLATION.
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
m Remove tape that covers
shipping strap, Pull to completely
remove the shipping strap with 2
colterpins from the inside of the washer,
Pull firmly to remove the end of
shipping strap from the back of the
washer, The shipping strap plug must
be completely removed from the
washer for the self-leveling legs to
be released,
Save the shipping strap for use in
Step 6.
Use new hoses and washers that
came with your Whirlpool washer.
Replace inlet hoses after 5 years of
use to reduce the risk of hose failure,
Inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are
found, When replacing your inlet
hoses, mark the date of replacement
on the label with a permanent
marker,
coupling washer
B Insert a flat washer into each
end of the inlet hoses, Check that
washers are firmly seated in
couplings,
Inlets are plastic.
Do Not stdp or
crossthread.
cold
water
inlet
vaive
hot water
inlet valve
| ) • Altach
hose to boltom inlet
valve opening first, Then second hose
to top inlet, Tighten couplings by
hand; then use pliers to make an
additional two-thirds turn,
Slide washer onto cardboard or
hardboard before moving across
floor,
_droin
_i_ hose
==_ stop
BTO prevent the drain hose from
coming off or leaking, it must be
installed per the following instructions:
1, Wet the inside end of the drain
hose with tap water, DO NOT USE
ANY OTHER LUBRICANT.
2, Squeeze ears of clamp with pliers to
open and place clamp over the
end of the drain hose,
3, While holding clamp open, work
end of drain hose onto drain
connector until drain hose contacts
ribbed stop,
4, Position clamp over the drain hose
area marked "clamp," Release
clamp, Clamp should be 1/4 inch
(6,4 mm) from end of drain hose,
mOpen clamp
and slide over "hook" (/l
end of drain hose to
secure the rigid and
corrugated sections /
together,
Slide washer onto cardboard or
hardboard before moving across
floor to avoid damaging floor
covering.
&
) • Move washer close to final
position, Put "hook" end of drain hose
into laundry tub or standpipe, Check
for proper length of drain hose,
PAGE 4