Before Use; Charging The Battery Pack (See Fig . A); Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside PSSA 20-Li A1 Manual Del Usuario

Before use

Charging the battery pack (see fig . A)

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket .
The control LED
♦ The green LED indicates that the charging
process is complete and the battery pack
ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
♦ Push the battery pack
♦ Switch off the charger
between successive charging sessions .
Also disconnect the power plug from the mains
power socket .
PSSA 20-Li A1
to the high-speed
(see fig . A) .
lights up red .
flashes, this means
has overheated and
both
into the appliance .
for at least 15 minutes
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
the appliance .
Removing the battery pack:
♦ Press the release button
battery pack

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram) .
The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting/changing the saw blade

WARNING!
► Remove the battery before carrying out
any work on the power tool (e.g. mainte­
nance, changing tools, etc.) as well as during
is
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury .
♦ Turn the quick-release chuck
stop and hold it in this position .
♦ Push the required saw blade
quick-release chuck
is
CAUTION!
► The teeth of the saw blade
downwards!
to click into place in
and remove the
.
as far as the
into the
as far as the stop .
must point
GB │ MT │
to check
51 ■