Storage; Problems With Your Appliance; Troubleshooting Guide - Avanti MBD5L Manual De Instrucciones

c) To clean the Mini Pub exterior surfaces.
•
Before cleaning the appliance, it is essential to turn off the main switch and then pull the plug
out of the socket.
•
The drip tray and cover can be removed from the unit either separately or together by pulling
it away from the unit. After cleaning the tray and cover can be returned to place in the
reverse manner.
CAUTION
Failure to unplug the Mini Pub could result in electrical shock or personal injury.

Storage

When the appliance is not used for a long period of time, remove the plug from the wall socket and
store the cable in the keg compartment of the unit. Store the appliance in a dry place out of children's
reach.
Replacing the Beer Lines / Hoses
To change the factory installed beer lines / hoses with the replacement hoses supplied with your unit.
Open the side panel.
Pull down the tap to release the dispensing line (short hose). Pull the hose completely out of the
dispensing tap. Pull the feeder line (long hose) out of the unit completely.
Unscrew the hose coupler. Remove the hose from the coupler.
Attach the new hose to the coupler by dipping the end in warm water to soften and attach to the
coupler. Screw the hose coupler together. Feed the dispensing line (short hose) into the tap and
secure by pulling down the tap handle.
You can solve many common unit problems easily, saving you the cost of a possible service call. Try
the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Unit does not operate.
Unit is not cold enough.
Vibrations.
The light does not work.

PROBLEMS WITH YOUR APPLIANCE?

TROUBLESHOOTING GUIDE

15
POSSIBLE CAUSE
AC or DC adapter is not plugged in.
The circuit breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher
setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The unit does not have the correct clearances.
Abnormal voltage.
Check to assure that the unit is level.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The light button is "OFF".