To Connect The Throttle Cable And Stop Switch Wires; To Install Blades And Trimmer Heads - Husqvarna 236R Manual De Usuario

To connect the throttle cable and stop
switch wires
1. Remove the air filter cover.
2. Install the throttle cable (A) through the carburetor
bracket (B).
C
3. Turn the cable adjuster sleeve (C) into the carburetor
bracket fully.
4. Put the slot fitting (D) on the carburetor. At this time,
the recessed hole (E) for the cable lug (F) is away
from the cable adjuster sleeve (C).
5. Rotate the carburetor throttle cam and move the
throttle cable (A) through the slot in the slot fitting.
6. Make sure the cable lug (F) drops into the recessed
hole.
7. Operate the throttle trigger some times to make sure
that it operates correctly.
8. Adjust the cable adjuster sleeve (C).
a) Make sure the stop on the carburetor throttle
cam touches the throttle stop correctly.
b) Make sure the cable position keeps 1-2 mm
between cable lug (F) and slot fitting when the
throttle trigger is fully released.
1-2mm
9. When the throttle cable (A) is adjusted correctly,
tighten the locknut (G).
1395 - 002 - 14.01.2020
A B
G
D E
F
10. Connect the stop switch wires (H) with the
connectors from the engine.
H
11. Install the stop switch wires and connectors with
clamp (I).
J
12. Install the dust cover (J).
13. Install the air filter cover.

To install blades and trimmer heads

WARNING: Only use the approved guard for
the blades. See
defective guard can cause injury.
WARNING: If you operate the product with a
grass blade, first install the correct
handlebar, blade guard and harness .
WARNING: If you do not install the the
blades correctly, it can cause injury.
1. Make sure that the lifted section on the drive disc/
support flange engages correctly in the center hole
of the blades.
I
Accessories on page 27 . A
11